Because the degradable film is a new type of degradable plastic film, which is different from ordinary plastic film. The degradable film can be degraded without causing harm and pollution to the environment. In a sense, the first generation of visible decomposition plastics, so the production process The requirements are very high, otherwise it cannot be manufactured. This uses a degradable membrane.film blowing machineOn the one hand, due to the needs of the public, on the other hand, due to the needs of the epidemic, the degradable film blowing machine has a broader market. In short, the degradation filmfilm blowing machineIs a large machine, should pay attention to several places when using, a little careless, it may cause danger. I will explain to you below.

1. Security issues.

For factories, safe production is important, especially for degradable film blowing machines. When safety problems cannot be ignored, firstly, standing people are not allowed in front of the film blowing machine. Secondly, gloves cannot be worn after deducting the incoming materials. In order to prevent the gloves from being involved in the machine rotation, sundries, especially metal appliances and some hard articles, cannot be piled up beside the machine to prevent things from being transferred into the barrel. Before starting up, check whether the power supply of each circuit is normal to prevent leakage problems so as not to affect production.

2. The use of the machine.

Good use of the machine will increase productivity. Therefore, it is necessary to check the deceleration device and lubrication device before the machine is turned on to avoid noise, because if the parts dry up, a harsh sound will occur. Therefore, it is important to check whether the power supply of each circuit is normal and whether the contact is good before starting up. If it is unqualified, it must be corrected in time to avoid the problem of leakage so as not to affect production.

3. Operation attention.

Within the range of film forming conditions, it is possible to appropriately increase the molding temperature, the temperature of the cooling air and the blow-up ratio. If these are greatly increased, the film turbidity will become larger and the gloss will be lost (or the gloss will be reduced), which is critical. When the discharge from the grinding opening is uniform and consistent, you can slowly pull the tube embryo with gloves, close one end of it at the same time, slowly adjust the recent regulating valve to properly press in the air, and then carefully string into the bubble stabilizing shelf and the word-in board to complete the operation. Before starting up, check whether the power supply of each circuit is normal. Can not let the pipe rupture, but also to ensure the symmetry of the production, so as to ensure the quality and quantity.

Attention to health issues.

When cleaning the extruder and grinding mouth, it can be treated with rods, islands, copper boards, or compressed air, so as not to damage the screw or break the smooth surface of the screw. So as not to affect the service life and efficiency of the machine.